Plumbing referrals for Phoenix & nearby townsCall: (602) 313-0394
(602) 313-0394

Water Softener in El Mirage, AZ

plumberphoenixaz.net

City wells on the west bank of the Agua Fria: reach an independent plumber who sets a softener to El Mirage water.

Softener questions in El Mirage?
Call now to be connected with a local plumber in El Mirage.
(602) 313-0394

El Mirage's city water is on the softer end for the Valley, at about 4 to 9 grains per gallon with an average of 7, and the city's own report suggests 7.5 grains as the setting for water softeners. A softener is still worthwhile for many homes, just sized and programmed for moderate hardness. Call the number on this page to be connected with a local plumber in El Mirage.

Water softener and brine tank with filters in a garage, water softeners & filtration in El Mirage, AZ

The City of El Mirage Water Services Division pumps groundwater from nine city wells spread through town and serves almost 40,000 people in El Mirage and the Original Town Site of Surprise. Its consumer confidence report lists hardness of 4 to 9 grains, averaging 7, and notes that 7.5 grains is the recommended softener setting. The city also runs its own wastewater reclamation facility, so brine from a softener goes to a regular household drain.

What to do now

  1. Decide what's bothering you: spots and scale, taste, or both. A softener only addresses the first.
  2. Check any existing softener's hardness setting. If it's set far above 7.5, it's wasting salt; far below, it's letting scale through.
  3. Test at the kitchen tap; individual wells vary, so your number may differ from the average.
  4. Look for a bypass valve so you can isolate the unit if it misbehaves.
  5. Note whether anyone in the house is watching sodium; potassium is an option.
Call now to be connected with a local plumber in El Mirage.
(602) 313-0394

Symptoms and likely causes

SymptomLikely cause
Salt disappearing quicklyHardness set too high or regeneration too frequent
Light spotting despite a softenerUnit undersized or resin aging
Water heater still rumblingSediment from before the softener; needs a flush
Brine tank dryFill valve or float not working
Valve clock wrong after a power outageOlder timer control without backup

Cost factors

Because El Mirage water is moderate, a smaller resin tank often covers a typical household, which keeps equipment and salt costs reasonable. Labor depends on whether a loop already exists, how far it is to a drain, and whether the old softener has to be removed. Reprogramming or repairing an existing unit is often the simplest path to better results; many units are simply set wrong. Adding a reverse osmosis faucet or a carbon tank raises the total. Plumbing permits go through El Mirage Building Safety, and the plumber can check whether your job needs one.

When you call, mention which part of town you're in and whether your home is on El Mirage water. If you live in the Original Town Site of Surprise, the same El Mirage water figures apply to you.

Water Softeners & Filtration questions in El Mirage

What hardness number should the softener be programmed with?
El Mirage's water report recommends 7.5 grains for water softeners. Your own tap test can fine-tune that.
Is an old softener worth repairing?
Usually worth a look first. At El Mirage's moderate hardness, many units just need a corrected setting, a new seal or a cleaned injector.
Will softened water raise the sodium in what I drink?
Only a little at 4 to 9 grains. Potassium chloride avoids it entirely if anyone is limiting sodium.
Does a softener do anything about chlorine taste?
No. A softener only removes hardness minerals. A carbon filter or kitchen RO unit is the fix for taste.

More plumbing services in El Mirage

Water Softeners & Filtration nearby

Call now to be connected with a local plumber in El Mirage.
(602) 313-0394

Last updated:

☎ Call (602) 313-0394