Shower Valve Repair in Glendale, AZ

In Glendale, a shower that won't stop dripping, changes temperature on its own or has a stubborn handle usually needs new parts inside the valve rather than a whole new valve. When the body is cracked or parts are gone, replacement is the fix. Call the number on this page to be connected with a local plumber in Glendale.

My Glendale home is from the 1980s. Is the valve worth saving?

Often, yes. The median Glendale home was built around 1985, so a lot of bathrooms here are on their first or second valve. Many valves from that era came from brands that still sell cartridges and seal kits, and a plumber can rebuild them through the trim opening. The trouble comes with discontinued models or valve bodies that are cracked, pitted or leaking at the pipe connections. Then replacing the valve makes more sense than chasing parts. If the bathroom has never been remodeled, mention that when you call so the plumber can bring parts that fit older designs.

Who do I call if the leak is on the city side?

A shower valve is entirely on your side of the meter, so its repair is your responsibility. Most of Glendale gets water from Glendale Water Services, which treats a blend of Salt, Verde and Colorado River water plus groundwater. One quirk: in the Hedgepeth Hills area, between Loop 101 and Mohawk Drive from 47th to 51st Avenue, water has historically been billed by the City of Phoenix even though Glendale treats and delivers it. Whichever name is on your bill is the one to call about a main break or meter problem. Glendale Water Services answers at 623-930-4100.

Will I need a permit for this work?

Glendale's Building Safety Q&A says a permit is required to replace drain and waste piping, and certain other plumbing work. A cartridge or seal swap is routine repair. If the plan involves cutting out the valve and rerouting supply lines, ask the plumber whether a permit applies and who pulls it. Glendale Building Safety, Codes and Services can answer the question directly.

Call now to be connected with a local plumber in Glendale.

(602) 313-0394

A quick local note

Glendale summers heat the cold lines in attics and slabs, so a shower that runs warm on the cold side for the first minute in July is normal. If it never cools down, or the handle no longer reaches full hot, the cartridge or its temperature stop may be at fault. A plumber can tell which in a short visit, and can also set the stop so the shower cannot reach scalding temperatures.

Shower Valve Repair questions in Glendale

Does it matter which water company serves my house?

For the valve itself, no. It is on your side of the meter. For a main or meter problem, call the utility on your bill: Glendale Water Services for most homes, or the City of Phoenix for parts of Hedgepeth Hills.

What kind of valve is likely behind the trim in an older home here?

With a median build year around 1985, many Glendale homes have original single-handle or two-handle valves. Some still take stock cartridges; discontinued ones usually get replaced.

Can a plumber limit how hot the shower gets?

Yes. Most single-handle valves have a rotational limit stop that caps how far the handle turns toward hot. A plumber can adjust it while the trim is off.

Why does water run from the tub spout and the showerhead at the same time?

The diverter in the tub spout or valve is worn or scaled. Replacing the spout or the diverter part usually solves it.